MaximalPower GIFI Power 3-Port Charging Plug Cable for YUNEEC Typhoon H Battery Charger

MaximalPower's 3-Port Charger Plug Cable provides a high-powered charging option for the YUNEEC Typhoon H battery, allowing for fast 45-minute recharge cycles. It is compatible with the Yuneec A10 Dual Balance Charger and the Hitec X2 AC Plus Dual Charger for optimum charging efficiency. 

✅ Charging / Discharging / Storage Charging Your Yuneec Typhoon H Battery (General Instructions)

1. Connect Charger Cables first

• Plug the banana cables (red = positive, black = negative) into the charger.
• Plug the balance cable (white connector) into the charger. 

2. Connect the Battery

• Connect your battery to the charging cable.

3. Enter Battery Settings

• Example battery: 4-cell (4S), 14.8 V, 8050 mAh LiPo

On your charger:

a. Select Battery Chemistry:

• • Choose LiPo (Lithium Polymer).

b. Select Mode / Function:

• • Choose one of the following depending on what you want:
    • Charge
    • Discharge
    • Storage Charge (recommended for long-term storage)

c. Set Charging Current:

• • Typically: 8.0A (≈ 1C rate for an 8050 mAh battery).
    
  • Do not exceed the battery’s recommended charge rate.

d. Set Cell Count / Voltage:

• • 14.8 V (4 cells)
  • Confirm the charger detects 4S automatically before starting.

NOTES:

1. These are general steps and may not apply to every charger model; refer to your charger manual for more information.
2. Never leave batteries charging unattended. 
3. Never attempt to charge defective/ swollen batteries. 

✅ Checking Battery Status With a Multimeter

Safety:

• Keep red and black banana leads separated and covered—never let them touch.

Steps:

1. Connect the charging cable (white connector) to the multimeter’s LiPo/balance port.
2. Connect the battery to the charging cable.
3. Press the “Cells” button on the multimeter. 
   You will see:

• • Total battery voltage
  • Individual cell voltages:
    • Cell 1
    • Cell 2
    • Cell 3
    • Cell 4

✅  Ideal Voltage Ranges (LiPo 4S Typhoon H Battery)

Full Charge Levels

• Per Cell: 4.20 V
• Total 4S: 16.8 V

Nominal Voltage/ Storage Voltage 

• Per Cell: 3.7-3.8 V
• Total 4S: 14.8 V
  (What the battery is “rated” as.)

Note: Voltage values are not exact — they vary slightly depending on battery condition, temperature, and the charger used, but they should be close to these ranges.

MAXIMUM POWER - MaximalPower's 3-Port Charger Plug Cable allows you to charge your Typhoon H battery with a High Power Charger at full charge

RAPID CHARGE - 45 minutes quick charging for a fast reload time; less charge time, more drone flying sessions

COMPATIBLE WITH - Can be paired with chargers for Yuneec A10 Dual Balance Charger or alternately, Hitec X2 AC Plus Dual Charger to charge HV LiPo batteries for maximum efficiency

SIMPLY & PERFECT USE - This charge cable provides more precise and powerful charge than the new charger cable for Yuneec Dual DY5 Charger, which suits less experienced users who simply want an easy plug-and-play charging solution

PACKAGE DETAILS - YUNEEC Battery and Charger not Included. This is for the Charger Cable only!

For Charging Batteries With This Cable:

Don’t Run The Battery All the Way Down - Never deep drain a LiPo battery, as it can damage the poles and reduce life; instead, recharge when energy starts to slow down. Unless you have NiCd battery exhibiting the memory effect, avoid deep draining.

Don’t Leave Battery on Charger - Remove battery after charging finishes; overcharging can damage it and shorten life. Not all chargers auto-shutoff.

Don’t Let Battery Overheat - Heat is deadly for LiPos as it may cause them to explode; if hot, let cool before charging/using.

Do Keep Battery Charged - Recharge cordless batteries as soon as you notice a decrease in power.

Do Use Battery Regularly - Use batteries regularly; else, opt for a plug-in version.

Do Charge Battery Completely: Be sure to leave the battery plugged in until it’s completely charged.

Do Store Battery Properly: Store battery in original case or cushioned bag in cool, dry place away from sun, heat, or humidity. Use plastic cap to prevent short-circuiting and protect terminals from breakage and moisture.

Supports: 3-Port Cable for LiPo Battery Charging
Compatible with: Yuneec A10 Dual Balance Charger, Hitec X2 AC Plus Dual Charger
Charges: Lithium-Polymer (LiPo) Battery
Package Weight: 1.9 oz
Item Dimensions: 13.10" length (Banana Lead Cables), 5.75" length (Balance Cable)
Package Size: 8 x 4"
SKU: 2000

30-Day No Questions Asked Returns with USA-based Brand Warranty and Customer Service available. Please contact us if you have any questions or concerns!